[VIDEO] How to Set up the CS500/CS500XD
How do I connect my CS500 series base to my desk phone?
To set up your CS500 series system with your desk phone:
- Plug one end of the power supply into the power jack on the back of the base and the other end into a power outlet. The Power On indicator light should glow solid white.
- Disconnect the handset coil cord from the desk phone and plug it to the telephone interface cable junction box.
- Plug one end of the telephone interface cable to the back of the base and the remaining end into the open handset port on the desk phone.
- Charge the headset for at least 20 minutes before first use (full charge takes 3 hours).
To check configuration:
- If your desk phone has a volume control, set it to mid-range.
- Look at the bottom panel of the base and make sure the default settings are correct. NOTE: For most phones, the factory default settings shown below will sound the best. If you have issues, however, click here to view our EHS Guide, which will provide the exact settings for your phone.
Listening volume dial = 3
Speaking volume dial = 3
Configuration switch = A
- Remove the handset from the desk phone cradle.
- While wearing your headset, press the call button on the headset.
- If you do not hear a dial tone, adjust the configuration switch (A-G) until you do.
- Dial a test call from the desk phone. If needed, fine tune the volume with the headset volume controls. You can also adjust the desk phone speaking and listening volumes on the bottom of the base.