Voyager Pro UC (B230/B230-M): How to Pair

How do I pair my Voyager Pro UC with my cell phone (or other Bluetooth device) and adapter?

To pair your Voyager Pro UC with your phone or other device:

On your cell phone, make sure Bluetooth is turned on.
Start with the headset powered off. Press and hold the power button for about 5-6 seconds until the light on the headset starts flashing an alternating red-blue. Release the power button and set the headset aside.
On your cell phone, go to the Bluetooth menu and search for (or add) a device. The cell phone should find the headset, which will appear as "Voyager PRO UC v2" in your list of devices.
If prompted for a passkey, enter 0000 (four zeros). Note: Do not be alarmed if your phone does not prompt you for a passkey, because many phones do not.

To pair your Voyager Pro UC headset to its Bluetooth USB adapter:

Note: The Bluetooth USB adapter comes pre-paired to the headset; however, if you find that you need to pair your headset to the adapter again, you can do so by performing the following steps.

Start with the headset powered off. Press and hold the power button for about 5-6 seconds until the light on the headset starts flashing an alternating red-blue. Release the power button and set the headset aside.
Plug the Bluetooth USB adapter into the computer. Once the devices pair successfully, the light on the headset stops flashing.

Note: For best performance, insert the USB adapter directly into the computer.