Explorer 240/395 Series: Headset Controls and Indicators
|Turn Headset On or Off||On: Slide the Power Switch to the "On" position.
Off: Slide the Power Switch to the "Off" position.
|On: Short blue flash
Off: Long red flash, then turns off
| On: Four rising tones
Off: Four descending tones
|Answer/End a Call||Tap the call control button||None||Brief low tone at the beginning or end of the call.|
|Reject an Incoming Call||Press and hold the call control button until you hear a low tone.||None||Low tone|
|Missed Call Indicator||Briefly press any button to cancel the indicator light.||Two simultaneous red/blue flashes, a pause, then two more red/blue flashes (repeating for 5 minutes or until cancelled).||None|
|Make a Call||Enter the number on your phone and press the Send button.||Blue flash every 2 seconds until the call is ended.||Ringing|
|Battery Level||To check, simultaneously press and hold both the call control and volume buttons for about 2 seconds. The indicator light flashes to show the charge level.||1 red flash - more than 2/3 full
2 red flashes - 1/3-2/3 full
3 red flashes - less than 1/3 full
|None when checking level.
Low battery tone indication: 3 tones when under 5 minutes talk time remaining.
|Adjust the Volume (during call)||Tap the Volume button to increase through 4 levels; tap at the top level to return to the lowest volume setting.||Single blue flash for every volume change.||Low tone at every volume level change. (Two tones at maximum volume level.)|
|Voice Dial||Press and hold the call control button until you hear a tone.||None||Single low tone: phone may prompt with "Name please" or tones.|
|Redial Last Number||Tap the call control button twice.||None||Two brief low tones|
|Transfer a Call from Headset to Phone
or from Phone to Headset
|While the call is in progress, press and hold the call control button until you hear a tone.||None||Long low tone when moving to phone; short low tone when moving to headset.|