スキップしてコンテンツに移動

Savi Office WO100: How to Set Up the Base

記事ID:

000001459

Setting Up the Base

Attaching the Charge Cradle to the Base Connect the headset charge cradle to the base.  To do this, push firmly on the cradle until the cradle snaps in to place. Connecting the Base to the Desk Phone
  1. Connect the telephone interface cable to the telephone interface cable jack on the base.
  2. Disconnect the handset coil cord from the desk phone.
  3. Connect the telephone interface cable to the now open handset port on the desk phone.
  4. Connect the handset coil cord to the telephone interface cable junction box.
  5. Place the handset back on the telephone cradle.
NOTE: If your phone has a built-in headset port, you should only use the headset port if you will not be using the HL10 lifter.  In this configuration, you must press both the headset button on your phone and the call control button on the headset to answer or end calls. Connecting the Power Supply to the Base
  1. Connect the base power supply into the power jack on the base.
  2. Connect the power supply to the outlet.
Positioning the Base The minimum recommended separation between your desk phone and the base is 6 inches. The minimum recommended separation between the base and computer is 12 inches.  Incorrect position can cause noise and interference problems.